3S-GE JDM Non-Turbo Engine Muliple problems: Celica 3sge swap into MR2 sw20 [Archive] - Toyota MR2 Message Board
Toyota MR2 Message BoardToyota MR2 GenerationsMK 2 MR2 - SW20Non-Turbo Engine Talk, Modifications, and SwapsPDAMuliple problems: Celica 3sge swap into MR2 sw20
3S-GE JDM Non-Turbo Engine, volts, wire, idle, engine, vacuum, throttle, full, accelerated, connected, sensor, connective, filter, clogged, fourth, multimeter, 4.54, wires, acceleration, resistance, check, lines, blowing, noticed, problems, addition, faulty, test, line, address, results, small, accelerate, fuel, hesitation, feel, slightly, consumption, point, replaced, shaky, fine, 900-1000, plastic, thingy, respectfully, pieces, split, hose, plugged
- Hey guys, I have recently experienced some problems with my MR2 SW20 (3S-GE, 115kw). Note worthy: I do not have much knowledge in mechanics and cannot do-it-my-self due to time and skill constraints. I hope some of you would be able to point me to the right direction.
One day the engine gave up and it had to be changed. It was difficult to get my hands on an mr2 engine in my country, but there were several 3S-GE 115kw engines from Toyota Celica.
However, the problems did not end there.