gen4 jdm 3sgte wont crank [Archive] - Toyota MR2 Message Board

relay, pull, jumper, quickly, transmission, neutral, make, wire, page, crank, 3sgte, electrical, wiring, impatient, gen4, bypassing, diagrams, locations, starter

Hey guys, I got a 1991 MR2 with USDM harness with a 4th gen JDM 3sgte and ecu. Car used to start but with a misfire. Now the car wont crank. When I turn to ignition, I just hear the relay click and the brake and engine cooling fan icons on the dash turn on. (e brake disengaged) Battery is good with around 12.6v. Starter is getting 12v from battery and brown connector when cranking. Starter was removed and connected to 12v. Gear pulls out and spins. Cleaned all grounds and checked