gen3 PFC into a '91 gen2 how to [Archive] - Toyota MR2 Message Board

sensor, &8226, gen3, wire, wires, gen2, plug, temperature, i&8217m, datalogit, mass, intake, decklid, black, engine, insert, open, paperclipe, correct, move, toyota, connect, wiring, info, install, sensors, http://img.photobucket.com/albums/v287/mrlaw/pinid.jpg, http://img.photobucket.com/albums/v287/mrlaw/diagrams.jpg, refer, position, solder, a13-a10, means, a8-a12, a12-a9, b4-a8, socket, http://img.photobucket.com/albums/v287/mrlaw/img_1336.jpg, side, http://img.photobucket.com/albums/v287/mrlaw/img_1337.jpg, http://img.photobucket.com/albums/v287/mrlaw/img_1338.jpg, clip, pins, size, case, a27-b14, left, tvis, tha1, lawrence

Hi all I’m putting up a how to wire a Gen3 PFC in a ’91-92 USDM gen2 I get so many emails asking for this info info , makes me feel like a PFC guru (which I’m not). You must double check the wiring using the BGB and the wiring diagram below To make the gen3 PFC work in the gen2 (WITHOUT THE DATALOGIT) you must install these extra sensors: • Gen3 mapsensor