DIY Throttle Cable Fix [Archive] - Toyota MR2 Message Board

cable, throttle, remove, homedepot, center, barrel, drill, ends, cables, housing, make, mark, body, http://lh3.ggpht.com/_5kzdthe1jfe/sicn3kukpvi/aaaaaaaaadi/t3sj4nsjvlq/s720/dsc04153.jpg, start, pulley, line, removing, hacksaw, place, fraying, cover, screw, work, points, write, complete, made, great, pilot, plastic, opening, brace, assume, http://lh4.ggpht.com/_5kzdthe1jfe/sicqldhaaji/aaaaaaaaaia/qeqveg0ahea/s720/dsc04189.jpg, condition, http://lh3.ggpht.com/_5kzdthe1jfe/sicpjeqyhji/aaaaaaaaagk/wjpot65ah1i/s720/dsc04178.jpg, depending, bought, drilled, tapped, hole, http://lh4.ggpht.com/_5kzdthe1jfe/sicq8ffai7i/aaaaaaaaaic/a1tzpcmmup0/s720/dsc04192.jpg, http://lh3.ggpht.com/_5kzdthe1jfe/sicqz4uzi9i/aaaaaaaaaiq/hueowbxbta8/s720/dsc04191.jpg, speed, hold, http://lh3.ggpht.com/_5kzdthe1jfe/sicqzsxfini/aaaaaaaaahw/latgreemlqe/s512/dsc04187.jpg, ontop, screws, slow

Well I had a fraying throttle cable that was getting hung up at times when backing off the throttle... After further inspection I noticed that the throttle cable was fraying and was getting caught up not letting the cable slide smoothly to close the throttle plate. Well after a call to