What wiring harness to use for JDM 3S-GE (lot of pics) [Archive] - Toyota MR2 Message Board

harness, swap, 3sge, finish, pics, 5sfe, wiring, told, work, turbo, local, carolla/camrys, junkyard, isit, harnesses, http://i87.photobucket.com/albums/k142/skimordie1/mr2/moto_0072.jpg, http://i87.photobucket.com/albums/k142/skimordie1/mr2/moto_0073.jpg, http://i87.photobucket.com/albums/k142/skimordie1/mr2/moto_0080.jpg, http://i87.photobucket.com/albums/k142/skimordie1/mr2/moto_0071.jpg, http://i87.photobucket.com/albums/k142/skimordie1/mr2/moto_0070.jpg, http://i87.photobucket.com/albums/k142/skimordie1/mr2/moto_0067.jpg, http://i87.photobucket.com/albums/k142/skimordie1/mr2/moto_0068.jpg, http://i87.photobucket.com/albums/k142/skimordie1/mr2/moto_0069.jpg, 90-91, appreciated, camry, completed, 3s-ge, found, 3sfe, engine, plugged, chopped, bunch, diagram, scratch, celica, start

Ok, so the 5sfe harness i the car is a bit chopped up, and it has a JDM 3sge in it but doesnt run because the swap was never completed. i found a 3sfe ECU in the car plugged in to the engine harness. and a bunch of 5sfe wiring diagram, not sure why though. Anyways, i need a harness to finish the swap and start from scratch so can finish this right. There is a 93 Camry, 90 Celica, and a few 90-91 carolla/camrys at the local junkyard. Isit possible to use any of these harnesses to get the 3sge to